Device Features Depending on the configuration, a four or five-speed two-shaft gearbox can be installed on the car, combined with a differential and final drive, the gear ratios of...
Removal and installation of mechanical transmission The gearbox without engine can be removed from the bottom of the vehicle. Disconnect the wire from the output «minus» battery and turn on IV gear (reverse for a...
Disassembly of the four-speed gearbox Install the washed gearbox on the stand for disassembly. Remove the fork and clutch release bearing. Remove the rear cover of the gearbox housing and remove the...
Assembly of a four-speed gearbox Thoroughly clean and check the technical condition of the gearbox parts, taking into account the following: if a defect is found on one of the elements of the input...
Removal and installation of the gear change drive Engage IV gear if it has not been engaged before. Remove handle 25 or 26 (pic. 3.38) from the gearshift lever 1 and remove the protective cover 24 as an assembly. Put...
Assembly features of a five-speed gearbox Output shaft assembly After installing the 1st gear gear, install the 1st and 2nd gear synchronizer and retaining ring. Make sure. that the annular groove of the...