Elements of the body and interior of the car Ford Escort 4

General information about the car body
Bearing body, stamped from steel sheets, welded by electric contact welding. Only the hood, doors, radiator grille and trim parts are removable. L, LG and Ghia versions...

Radiator grill — removal
The radiator grill is attached to the body with spring clips. Withdrawal 1. Press the clip from above and push forward the upper part of the grille. 2. Remove the...

Hood opening cable — removal and installation
Attaching the cable to the hood latch 1 - cable sheath; 2 - cable; 3 - hood lock; 4 - front cross member Removal and installation 1. Unscrew the 3 screws on the steering...

Front bumper — removal and installation
Front bumpers of cars manufactured before 1985 1 - radiator holder; 2 - radiator grille; 3 - front spoiler; 4 - the base of the bumper; 5 - sidewalls; 6 - fangs; 7 -...

Rear bumper — removal and installation
Attaching the rear bumper to the body 1 - nut; 2 - bracket; 3 - bumper Removal and installation 1. Disconnect the license plate light connector. Vehicles manufactured...

Trunk lid (Orion) — removal and installation
Trunk lid (Orion) 1 - rubber bushing; 2 - connector The arrows indicate loops. Removal and installation 1. Remove ground wire from battery. 2. Raise the trunk lid and...

Upholstery of the ceiling — removal and installation
1. Remove the windshield, rear side windows of the body and their seals. 2. Remove the seal for the door openings and the rear door from above. 3. Remove the dome light....

Front seats — removal and installation
1. Move the front seat forward as far as it will go. 2. Unscrew the bolts securing the rear of the skid to the bottom of the body. 3. Slide the seat back as far as it...

Rear seats — removal and installation
The seat cushion is attached to two loops located at the edges of the seat. 1. After unscrewing the Torx bolts, lift the seat cushion up and out of the vehicle. 2. The...

Outside mirror — removal and installation
Dimensions for making a key 41-014 Removal and installation 1. Remove the decorative inner mirror trim with a screwdriver, and the removal must begin from the bottom up....

Interior mirror — removal and installation
1. The interior mirror is glued to the windshield, so the adhesive must be broken to remove the mirror. 2. New windshields and mirrors are shipped with adhesive applied...

Air control panel
Elements of the heating and ventilation system 1 - air inlet housing; 2 - heater fan housing; 3 – fan; 4 - air distributor; 5 - lateral air channels; 6 - nozzles; 7 -...

Heating control cable adjustment
Location of heater control cables on the dashboard on models from 1986 1 - air flow adjustment cable; 2 - temperature control cable; 3 - gear ends of the cables; 4 -...

Heater fan — removal
Heater fan 1 - housing connection bracket; 2 - resistor Fan motor 1 - capacitor; 2 – three-stage regulator; 3 - electric motor; 4 - brushes Withdrawal 1. Remove ground...