Vacuum booster with bracket
1 - plug with a level sensor; 2 - gasket; 3 - tank; 4 - the main brake cylinder; 5 - check valve; 6 - vacuum hose; 7 - vacuum brake booster; 8 - shaft bracket; 9 - bushing; 10 - shaft; 11 - spring; 12 - bushing; 13 - thrust; 14 - bracket; 15 - protective cover
Removal and installation
1. Remove the fastening clip of the brake booster valve tappet with the rod on the pedal axle.
2. Remove the brake fluid from the reservoir with a syringe.
3. Unscrew the nuts securing the pipelines to the main brake cylinder, remove the pipelines and plug them with plugs.
4. Disconnect the connector from the brake fluid level sensor and remove the reservoir cap.
5. Unscrew the fastening nuts and remove the brake master cylinder from the vacuum booster.
6. Remove the vacuum hose from the booster.
7. Unscrew the nuts securing the vacuum booster and remove it.
8. The vacuum booster is installed in the reverse order of removal.
Visitor comments