Body wash and car care Ford Fiesta 4

Interior cleaning
The main materials needed for interior cleaning: lint-free cloths are essential for wet and dry cleaning; brushes for cleaning clothes (for cleaning seat cushions);...

Car wash
Washing a car on the street is now prohibited in many cities. There are good reasons for this: during washing, oil residues and other harmful substances enter the sewer...

Car wash outside
SEQUENCE OF WORK 1. Close all doors and windows. 2. Clean wheel arches, caps and sills. You can wash off the remaining dirt when washing. 3. Rinse the bottom with a jet...

Engine wash
Over time, oil, dust and insects form a significant amount of dirt in the engine compartment of your Fiesta, which not only covers the engine and other parts of the car,...

Lubrication of hinges and assemblies
Lubrication helps to reduce friction of parts. On hinges and assemblies with narrow passages where grease cannot penetrate, use a lubricant spray. Friction surfaces are...

Paintwork care
Regular paintwork maintenance is a job that always pays off, as matte, scratched paintwork surfaces significantly detract from the Fiesta's appearance. The new surface...

Elimination of damage from stone impacts
While driving, fine dust and pebbles fly towards your Fiesta, which causes micro cracks in the paintwork on its front. This happens most often in winter, when an icy...

Polishing small scratches
SEQUENCE OF WORK 1. Thoroughly clean damaged areas with gasoline or thinner. 2. If your vehicle's paintwork has paint from another vehicle, carefully buff the area with...

Removing deep scratches
SEQUENCE OF WORK 1. For deep scratches on bumpers, fenders, or doors, remove body part before repair. The result of the repair will be better and it will be easier to...

Windshield wiper and washer
Clean windows are an important condition for traffic safety. To ensure good visibility in all road conditions, the Fiesta has two windshield wipers. The windshield wiper...

Checking the windshield wiper and washer
constant control SEQUENCE OF WORK 1. Turn on the ignition, press the wiper switch lever. 2. Check if the wiper works at both speeds and returns to its original position....

Filling fluid into the windshield washer reservoir
constant control SEQUENCE OF WORK 1. In summer, add tap water to the windshield washer reservoir. The addition of a portion of the cleaning agent greatly enhances the...

Brush replacement
20000 km, 12 months SEQUENCE OF WORK 1. Raise the wiper arm. Pic. 3.21. The direction of pressing the small protrusion of the blade pivot and the sequence of movement of...

Windshield washer jet adjustment
Together with the heated glass, the jets on the hood are also heated. They are precisely adjustable with a needle or paperclip. SEQUENCE OF WORK 1. Use a needle or paper...

Removing jets
Clogged jets must be immediately removed and blown out with compressed air in the direction of the water hose connection. In the absence of compressed air, you can clean...

Removing the wiper arm
SEQUENCE OF WORK windshield wiper 1. Use a small screwdriver to pry off the protective cap on the lever shaft. Use sticky tape on the glass to mark the initial position...

Removing the windshield wiper motor
SEQUENCE OF WORK 1. Raise the wiper arms, turn on the gearmotor for 30 seconds. Turn off the gearmotor - the wiper arms should return to their original position. 2....

Removing the rear window motor
SEQUENCE OF WORK 1. Disconnect a wire from the negative plug of the storage battery and remove the screen wiper lever. Pic. 3.28. Rear window cleaner: 1 – wiper blade; 2...

Possible malfunctions of the wiper brush drive mechanism, their causes and methods of elimination