Removing jets

Clogged jets must be immediately removed and blown out with compressed air in the direction of the water hose connection. In the absence of compressed air, you can clean the jet with a thin wire. If that doesn't help, replace it. To prevent clogging of the jet, insert a regular fuel filter into the hose.



SEQUENCE OF WORK

1. Open the hood and remove the noise insulation panel, after removing the clips with a screwdriver.

2. Before disconnecting the hose from the jet with a lighter, warm it up a little.

3. Squeeze the mounting tabs and simultaneously push the jet out of the hood (or pry it with a screwdriver, placing a rag under the screwdriver, for example, so as not to damage the paintwork).

4. To install, insert the jet from the outside into the hood until you hear a click. Be sure to make sure the jet is firmly seated in its place, otherwise it will not be possible to adjust it.

5. Connect a hose to the jet

6. Fix the soundproofing panel.