Withdrawal
WARNING: If brake fluid comes into contact with the paintwork, the affected area must be washed immediately with cold water.
1. Loosen wheel nuts.
2. Raise and support the vehicle. See Section 100-02 for more information.
3. Remove the wheel.
4. Disconnect the brake hose from the support bracket.
5. Loosen the brake hose tension.
- 1.Pinch the brake hose with a clamp.
- 2. Loosen the nipple connection of the brake hose.
6. Remove the front brake pads. For more information, see the Pads - Front Brakes chapter. available in this section.
7. Disconnect a support from a brake hose. Plug the brake hose to prevent leakage of brake fluid and ingress of dirt.
Installation
1.
NOTE: After installation, bleed the brake system. See Section 206-00 for more information.
When installing, follow the removal procedure in reverse order.
Visitor comments