Headlight Beam Adjustment

1. Fine adjustment of headlights cannot be done without special optical equipment. Therefore, such an operation must be performed at dealers.

2. After replacing a bulb or headlight assembly, or if misaligned due to accidental damage, you can temporarily adjust the headlight beam.

3. To do this, turn the screws located on the top of the headlight unit (see fig.8.3).



4. Front fog light beam adjustment can be done by turning the screw with a hex key through the headlight bezel (see fig.8.4).



5. It is necessary that before starting the adjustment, the car was on a horizontal platform, and the tire pressure corresponded to the regulated one.

6. To install the suspension, shake the front of the car by pressing it several times. It is best if an average-sized person is sitting in the driver's seat when making adjustments, and the fuel tank is full.

7. If the vehicle has a power beam tilt system, before making any adjustments, set the system switch to "ABOUT".

8. After performing a temporary adjustment, always promptly perform a fine adjustment at your dealer.