Interior (internal elements) Ford Mondeo 1 and 2

Carpet and upholstery care
Upholstery and carpets should be vacuumed regularly. If they are heavily soiled, they must be removed from the vehicle for cleaning or washing and dried thoroughly...

Removal and installation of the panel of internal facing of a door
Withdrawal 1. Disconnect the negative battery cable. 2. Gently pry out the plastic cover using a small screwdriver. Turn out the screw and remove a fringing of the...

Removal and installation of a window regulator of a door
Withdrawal 1. Remove the glass ( paragraph 12 ). 2. Let go (without opening completely) power window and hand/motor handle mounting bolts (see fig. 13.2, a-d). 3. Tilt...

Removal and installation of the door handle and lock components
Withdrawal External front door handle 1. Remove the door inner lining panel ( paragraph 11 ). 2. Use a knife to cut off the adhesive tape so that the sponge insulator...

Removal and installation of an internal mirror
Withdrawal 1. Using a thin strong rope or fishing line, separate the mirror from the knot, destroying the adhesive connection between them. Your assistant should hold...

Components of the central locking system
Examination 1. This system has a self-test mode, which is activated when one of the interlock microswitches is actuated eight times within ten seconds. The buzzer...

Removal and installation of seats
Withdrawal Front seat 1. On models with power or heated seats, or with side airbags, disconnect the negative battery cable ( chapter 5A ) and move the wire away from the...

Removal and installation of seat belts
Warning: Be careful when servicing the special belt tensioner (capture). On models prior to 1996, it contains a powerful spring that could cause injury if triggered...

Removal and installation of panels of internal facing
Withdrawal Sunshield 1. Disconnect interior mirror illumination wiring (in the presence of). 2. Turn out screws and remove a sun-protection peak. 3. Remove the cover,...

Removal and installation of the central console
Withdrawal 1. Disconnect the negative battery cable. 2. Remove the ashtray from the front panel and pull out the cigarette lighter trim (see fig. 30.2, a, b). Models...

Removal and installation of the ceiling panel
Withdrawal 1. Disconnect the negative battery cable. 2. Remove the sunroof switch (if available - see chapter 12). 3. Remove the sunroof opening handle (in the presence...

Removal and installation of a glove box
Withdrawal 1. Open the glove box. Using a screwdriver, gently press on the side of the glove box near its hinge to release the glove box from the plastic retainer (see...

Removing and installing the front panel
Withdrawal 1. Disconnect the negative battery cable. 2. On pre-1996 models, remove the windshield wiper arms (chapter 12). Then remove the panel located directly in...

Removal and installation of the wheel arch locker
Withdrawal Front locker 1. Apply the parking brake, raise the front end and place it on stands. If desired, remove the wheel for better access. 2. If you are removing...

Fuel filler flap and opening cable
Withdrawal Throat flap 1. From inside the trunk, remove the lining clips. Bend down the lining panel on the right side and insert the emergency opening cable into the...