Car automatic transmission Ford Mondeo 1 and 2

Specifications and tightening torques
Connection tightening torques Name N·m Selector cable support bracket 19 Torque converter to faceplate 36 Transmission to engine 40 Faceplate to crankshaft 112 Coolant...

General information about automatic transmission
The CD4E automatic transmission is controlled by an electronic device of the engine management system. It has two modes (economical and sporty), as well as a top gear...

Troubleshooting
1. In the event of a malfunction, first of all check the level of the working fluid ( Chapter 1 ). If fluid leaks are found, check cuffs ( chapter 7 ). Also check for...

Removal, installation and adjustment of a cable of the selector
Withdrawal 1. Apply the parking brake, raise the front end and place it on stands. Remove the left front wheel. 2. Remove the air mass meter and chute ( chapter 4 ) to...

Removing and installing the selector assembly
Withdrawal 1. Remove the central console (chapter 11). 2. Set the parking brake, raise the front end and place it on stands. 3. Working under the vehicle, remove the...

Removal and installation of a gear wheel of a drive of a speedometer
Withdrawal 1. This gear is mounted on the right rear of the transmission. Apply the parking brake, raise the front end and place it on stands. 2. Remove the nut and...

Selector lever position sensor
Withdrawal 1. Remove the air mass meter and chute ( chapter 4 ) to access the sensor, which is mounted on top of the transmission. 2. Disconnect the wiring connector...

Removal and installation of automatic transmission
Note: Read the description of the entire procedure, and especially the instructions for lifting equipment. Depending on your funds, you can first remove the power block,...

Transmission repair
When a malfunction occurs, first of all, you need to determine which system it is connected with - mechanical, electrical or hydraulic. Such diagnostics require special...