Replacing the power window rear door

You will need: TORX T25 wrench.

1. Remove the back door upholstery (see Removing and installing tailgate trim).

2. Remove rear door glass (see Rear Door Glass Replacement).

NOTE: It is not necessary to remove the glass from the door, it is enough to disconnect it from the power window and fix it in the highest position, for example, using a screwdriver, pieces of PVC pipe of a suitable diameter or masking tape.

3. Pressing the latch..



4.... disconnect the wiring harness connector from the power window connector.



5. Turn out the lower..



6.... and the upper screws for fastening the slider guide of the power window..



7.... and remove the power window from the door cavity through the technological hole in its inner panel.



8. Install the power window in the reverse order of removal.