The steering column switches are part of the steering column module and cannot be replaced individually.
In the event of their failure, the module is replaced as an assembly.
You will need a TORX T25 key.
1. Disconnect a wire from the minus plug of the storage battery.
2. Remove the top and bottom of the steering column cover (see Removing and installing steering column cover).
3. Remove the steering wheel (see Steering wheel removal and installation).
4. Squeezing the latch..
5….disconnect the wiring harness block from the steering column switch module.
6. Pressing the latch..
7.... Disconnect the wiring harness connector from the driver's airbag contact ring.
8. Turn out on two bolts of fastening of the module to a steering column ahead …
9….and above…
10….and remove the module.
11. Install the parts in the reverse order of removal.
Visitor comments