Withdrawal
Use a T30 Torx screwdriver to unscrew the screw -1- two turns through the hole in the cross support.
Remove the lamp -2-.
Turn lamp holder -3- to the left and remove.
Slightly press the bulb -4- into the holder, at the same time turning it to the left and remove it.
Installation
Insert the new bulb into the socket, turn to the right and lock into place.
Insert the cartridge into the lantern and secure by turning to the right.
Install the lantern, while first inserting the retaining spring -5- into the hole -6-, then push the lantern inwards.
Check that the lantern is securely installed in the hole and tighten the fastening screw.
Visitor comments