1. Disconnect the wire from the terminal «minus» battery.
2. Remove the left front fender liner (see «Removal and installation of wheel mudguards and fender liner»).
3. Separate hoses of a washer of glass of a wind window and a door of a back.
4. Squeeze the clamp of the washer electric pump harness block..
5.... and disconnect the block from the outputs of the electric pump.
6. Turn out the top bolt of fastening of a washer reservoir.
7. Turn out the bottom bolt of fastening of a washer tank.
8. Remove the tank from the bracket located on the side member..
9.... and remove the washer reservoir from the wing cavity.
10. Drain the fluid from the washer reservoir into a previously prepared container.
11. Disconnect the windshield washer hoses from the fittings of the electric pump..
12.... and glass tailgate windows.
13. Remove the electric pump.
14. Pry off the sealing sleeve of the electric pump with a screwdriver..
15.... and remove the sleeve from the hole in the tank.
Note. The sealing sleeve of the electric pump is made in one piece with the filter element.
16. If it is necessary to replace the hoses, remove them from the holders on the washer reservoir and the hood and remove the hoses.
17. To replace the washer jet, disconnect the hose from the washer fitting.
18. Press the retainer with a screwdriver..
19.... and remove the washer jet from the hole in the hood.
20. Install all previously removed parts in reverse order.
Visitor comments