Vehicle break-in

Ford Fusion cars are distinguished by high quality workmanship and materials used, so they are immediately ready for full-fledged operation and do not require special break-in. However, during the initial period of operation of the car (first 1500 km) there is an intensive running-in of details. To improve the reliability, durability and economy of the car during its further operation and after a major overhaul of the engine, we recommend that you follow the following rules for operating the car.

1. Before each departure, check and, if necessary, adjust the air pressure in the tires.

2. Do not allow the engine to run at an increased speed of the crankshaft (more than 4500–5000 min^-1).

3. In time, according to road conditions, shift to a lower gear to avoid unwanted engine overloads.

4. For better running-in of brake pads, try to avoid sudden braking.

5. Avoid riding in deep snow, sand, mud as much as possible.

6. Do not tow a trailer and if possible try to avoid towing other vehicles.

7. Apply «soft» driving style, avoiding sudden acceleration, braking, maneuvering.

8. Do not exceed the speed of 130 km/h even on downhill slopes.

9. Periodically check and, if necessary, adjust the tension of the accessory drive belts (generator and power steering pump, air conditioning compressor). During the initial period of operation, the belts can be most intensively stretched.

10. Monitor the condition of all fasteners of the car and, if necessary, tighten them. Pay special attention to fastening the wheels, steering parts, front and rear suspensions, the exhaust pipe of the exhaust system to the engine exhaust manifold.

After break-in (1500 km) visit a service station for the first scheduled maintenance. In order for the warranty to continue to operate, require the service station workers to enter a mark on the maintenance in the service book coupons.

After a run of 1500 km, the restrictions are removed, but for the final running-in of engine parts, the car must travel approximately 3000 km.