Steering with power steering of the car Ford Scorpio 1

Technical characteristics of the steering with power steering
Design description The power steering system is a helical rack and pinion power steering from ZF or Cam Gear. Hydraulic vane pump from Saginaw. The safety steering...

Removal and installation of steering gear
Power Steering A - ZF brands, B - Cam Gear brands, 1 - drive gear, 2 - drive gear housing, 3 - gear rack housing, 4 - gear rack, 5 - piston and connector, 6 - steering...

Disassembly and assembly of the CAM GEAR steering gear
Disassembly 1. Remove the oil supply and return lines from the hydraulic booster. Seal the ends of the pipelines with plugs. 2. Disconnect the ball joints from the tie...

Disassembly and assembly of ZF steering gear
Disassembly 1. Disconnect the oil supply and return lines from the hydraulic booster. Plug the ends of the pipelines with plugs to protect against contamination. 2....

Removal and installation of a steering column
These steps are the same as for the non-power steering system (see subsection 9.2.6 ).

Disassembly and assembly of the steering column
These steps are the same as for the non-power steering system ( see subsection 9.2.7 ).

Removal and installation of the pump of the amplifier of a steering
Power steering hydraulic pump 1 - pump, 2 - inlet pipeline, 3 - pressure pipeline, 4 - outlet pipeline, 5 - tank, 6 - pulley, 7 - flange, 8 - bearing, 9 - drive shaft,...

Dismantling and assembly of the pump of the hydraulic booster
Power steering pump 1 - drive shaft; 2 - sealing ring; 3 - body; 4 - O-rings; 5 - flange; 6 - guides; 7 - ring; 8 - rotor; 9; 13 - retaining ring; 10 - clamping flange;...

Replacing and adjusting the tension of the drive belt
1. Remove ground wire from battery. 2. On vehicles with air conditioning, remove the compressor drive belt. 3. On vehicles with OHC engines, loosen the alternator belt...

Replacement of protective covers of the steering mechanism
1. Remove the tie rod end from the corresponding side. 2. Loosen clamps (indicated by arrows) fastening the protective cover and pull the cover along the steering rod....

Bleeding air from the power steering system
1. Unscrew the oil fill plug in the power steering system and check the oil level in the system (with cold oil). If necessary, add oil to the required level. Attention!...