Unscrewing the fan clutch
Wrench for unscrewing the fan clutch
Dimensions: X=25mm, Y=12mm
Bolts for fastening the impeller to the coupling
Hydraulic fan clutch
1 - front part of the housing, 2 - bimetallic spring, 3 - housing with cooling fins, 4 - valve, 5 - inlet, 6 - seal, 7 - rotor, 8 - drive shaft, 9 - liquid chamber, 10 - ring
Withdrawal
1. Disconnect the ground wire from the battery and remove the upper radiator cover.
2. Unscrew the fan clutch from the coolant pump hub. For unscrewing, a curved open-end wrench s=32 is required.
Attention! The fan clutch nut has a left-hand thread.
3. When unscrewing the nut of the fan coupling, tighten the V-belt and thus prevent the hub from turning.
4. Unscrew 4 bolts and remove the impeller from the coupling.
Installation
Installation is carried out in the reverse order of removal.
Visitor comments