Car automatic transmission Ford Taurus 1 and 2

Torque specification
Tightening torques for automatic transmission N·m (foot pounds) Neutral Switch Bolt 9.5-122 (7-9) Bolt of fastening of a check point to the engine AXOD gearbox 55.6-68...

General information about automatic transmission
On these car models, two types of automatic transmissions are used - 4-speed AXOD and 3-speed ATX. This part of chapter 7 contains all the information regarding...

General diagnostics of automatic transmission
Note: The failure of an automatic transmission can be caused by five main causes of poor engine performance - improper adjustment, failure of the hydraulic system,...

Removal and installation of the automatic transmission drive mechanism
Floor drive Lever and drive housing 1. Grasp the drive handle tightly and pull it up to remove it. 2. Remove the center console ( chapter 11 ). 3. Unscrew the four...

Removal and installation of an automatic transmission
Withdrawal 1. Disconnect the wire from the negative battery terminal. 2. Remove the hood and inner liner of the left front fender ( chapter 11 ). 3. Remove the air...

Adjustment of the automatic transmission drive mechanism
Box type AHOD 1. Set the selector lever to position "Overdrive" (overdrive), opposite the rear "Stop" and have a helper support it in that position as you adjust. 2....

Throttle valve (TV) control mechanism adjustment
Box type AHOD 1. Throttle valve cable (TV) AHOD system only needs to be adjusted if the cable, bracket, gearbox, main control unit or throttle control unit have been...

Checking and replacing the gearbox suspension
1. Remove the left front wheel and fender arch ( chapter 11 ). 2. Insert a lever or a large screwdriver into the opening of the suspension, swing it up and down (see...

Replacing and adjusting the neutral start sensor
1. Disconnect the wire from the negative battery terminal. 2. Set the shift lever to "neutral". 3. From the side of the engine compartment, unscrew the nut that secures...